Transportation of clay, sand, raw rocks.

Belts are certificated.
1.1; 1.2; 2.1; 2.2
Specifications 38105 1332-04

Transportation of clay, sand, raw rocks.

Belts of the types 1.1 – 1.2 are oriented on the transportation of ferrous and nonferrous metal ores and hard rocks lumps up to 500 mm, logs with the diameter up to 900 mm and other materials.

Belts of the types 2.1 – 2.2 are oriented on transportation of unscreened coal, clay, cement, soft rocks and other little abrasive materials lumps up to 150 mm.

Ambient temperature: from -45°C to +60°C.

Belts are certificated. 1.1; 1.2; 2.1; 2.2

Hard-combustible conveyor belts are oriented on service in coal and ore mines and quarries.

Ambient temperature: from -30°C to +60°C.

Cloth type: TK; TLK; ER; ERR.

Belts are certificated. 1.1; 1.2; 2.1; 2.2. All-Union Standard 153-12.2-001-97

Transportation of cargos with the duration temperature of 100°C, 150°C and 200°C.

Maximum short temperature, 2 temperature limits from +300°C to +400°C.

Belts are certificated.
2T1 2T2 2T
1,1; 1,2; 2,1; 2,2.

Similar to general-purpose conveyor belts. Ambient temperature: from -60°C to +60°C.
Belts are certificated. 1M; 1.2M; 2M

Transportation of small-sized lumps, abrasive and medium lumps of little abrasive materials.

Belts of the types 1.1 – 1.2 are oriented on the transportation of ferrous and nonferrous metal ores and hard rocks lumps up to 500 mm, logs with the diameter up to 900 mm and other materials.

Belts of the types 2.1 – 2.2 are oriented on transportation of unscreened coal, clay, cement, soft rocks and other little abrasive materials lumps up to 150 mm.

Ambient temperature: from -45°C to +60°C.

Belts are certificated. 1.1; 1.2; 2.1; 2.2 Specifications 38105 1332-04

Transportation of coal up to 700 mm and rock lumps up to 500 mm. Approved and meant to be used in not gaseous-and-dusty ore and coal mines, open-cast mining and concentrating plants of ore, non-metal and coal branches, and other industrial facilities under the control of Russian mines technical inspectorate.

Ambient temperature: from -30°C to +60°C.

Belts are certificated. 1.1; 1.2; 2.1; 2.2

As a first step it is necessary to scour corrosion and contamination off a drum. After that set a single locking plate perpendicular to the drum surface and parallel with its axis. Weld a single locking plate on the drum surface. Then weld a liner and a double locking plate. In case the liner is bent under the drum edge not fully fix it with a clamping tool. Go over the setting to the drum centre and then leave a space (approximately equal to the distance between two single locking plates) and go on lining the drum till the end. Provided in the end result any part of the drum remains unlined and this part is less than the liner width you must just cut the liner off to the required width.